z table bed spikes

Post Reply
xarget
Posts: 12
Joined: Sat Sep 16, 2017 4:09 pm
Contact:

z table bed spikes

Post by xarget »

is anyone using spikes or cleats or pegs or anything to raise workpiece off the table to cut it or just cutting it on the bed ? if so what are you using ?
Techgraphix
Posts: 492
Joined: Fri Jan 20, 2012 1:39 pm
Location: Appelscha, the Netherlands
Contact:

Re: z table bed spikes

Post by Techgraphix »

I raise material about 4mm from the bed with a few T-shirt-shaped pieces of acryl (3mm thick)
These t-shapes where lasered from a few pieces of rest material. They cost nothing and when they are worn i just replace them..
Kees
Post Reply

Return to “D40/K40 small chinese CO2 laser machine”

Who is online

Users browsing this forum: No registered users and 4 guests