Page 1 of 1

z table bed spikes

Posted: Mon Oct 02, 2017 1:19 pm
by xarget
is anyone using spikes or cleats or pegs or anything to raise workpiece off the table to cut it or just cutting it on the bed ? if so what are you using ?

Re: z table bed spikes

Posted: Mon Oct 02, 2017 2:45 pm
by Techgraphix
I raise material about 4mm from the bed with a few T-shirt-shaped pieces of acryl (3mm thick)
These t-shapes where lasered from a few pieces of rest material. They cost nothing and when they are worn i just replace them..
Kees