z table bed spikes
-
- Posts: 12
- Joined: Sat Sep 16, 2017 4:09 pm
- Contact:
z table bed spikes
is anyone using spikes or cleats or pegs or anything to raise workpiece off the table to cut it or just cutting it on the bed ? if so what are you using ?
-
- Posts: 492
- Joined: Fri Jan 20, 2012 1:39 pm
- Location: Appelscha, the Netherlands
- Contact:
Re: z table bed spikes
I raise material about 4mm from the bed with a few T-shirt-shaped pieces of acryl (3mm thick)
These t-shapes where lasered from a few pieces of rest material. They cost nothing and when they are worn i just replace them..
Kees
These t-shapes where lasered from a few pieces of rest material. They cost nothing and when they are worn i just replace them..
Kees
Who is online
Users browsing this forum: No registered users and 1 guest