z table bed spikes

Posts: 12
Joined: Sat Sep 16, 2017 4:09 pm

z table bed spikes

Postby xarget » Mon Oct 02, 2017 1:19 pm

is anyone using spikes or cleats or pegs or anything to raise workpiece off the table to cut it or just cutting it on the bed ? if so what are you using ?

Posts: 487
Joined: Fri Jan 20, 2012 1:39 pm
Location: Appelscha, the Netherlands

Re: z table bed spikes

Postby Techgraphix » Mon Oct 02, 2017 2:45 pm

I raise material about 4mm from the bed with a few T-shirt-shaped pieces of acryl (3mm thick)
These t-shapes where lasered from a few pieces of rest material. They cost nothing and when they are worn i just replace them..

Return to “D40/K40 small chinese CO2 laser machine”

Who is online

Users browsing this forum: No registered users and 6 guests