Z Table Driver

Post Reply
Henrik
Posts: 1
Joined: Thu Feb 23, 2017 1:44 pm
Contact:

Z Table Driver

Post by Henrik »

Hi,

After a loooooooong shipping time from US to Sweden i finally assembled my Z table without any problem.

I also bought the suggested driver DM422 from Lightobject.
Want to use it in a standard D40/K40 with my smoothie board clone. No display on the machine.

How do I wire it to move the z table up and down? :roll:
How to wire it between motor and driver is no problem, but on the other side? :)
Post Reply

Return to “D40/K40 small chinese CO2 laser machine”

Who is online

Users browsing this forum: No registered users and 4 guests