Arcing problem?

pitunia
Posts: 1
Joined: Fri Jul 15, 2016 10:15 pm

Arcing problem?

Postby pitunia » Sun Nov 27, 2016 8:51 pm

Hello,

I have been in the process of upgrading my laser for the past 2 months or so on and off and it has been frustrating to say the least. Right now I am encountering a problem with arcing I believe? I rigged up all the electronics and everything was working with the exception to a little bit or arcing. During the first few test cuts, the laser power would fade throughout the cut so I covered all exposed wire insulation with the provided silicon tubing. Now when I press on the laser fire button, the laser fires continuously without any problems. When I try to run an engrave program, the machine engraves for about 1 second and then the controller resets. I hear some arcing inside when this is happening so I don't really want to continue messing around with it. Any suggestions would be greatly appreciated.

Thanks,
James

bsm2003
Posts: 31
Joined: Sat Sep 10, 2016 1:17 pm

Re: Arcing problem?

Postby bsm2003 » Mon Nov 28, 2016 11:49 am

What controller are you using? I doubt it's arcing while engraving if it's not arcing when cutting.


Return to “D40/K40 small chinese CO2 laser machine”

Who is online

Users browsing this forum: No registered users and 2 guests