Power and speed settings not sending to laser

Post Reply
SonicDad
Posts: 1
Joined: Thu Aug 04, 2016 5:08 pm
Contact:

Power and speed settings not sending to laser

Post by SonicDad »

Hi All,
I've upgraded my K40 laser with the X7 DSP upgrade kit and have cut the duck out of foam board as well as engraved a panel design from LaserCad. My issue now is that when I set the power/speed to cut in LaserCad and send it to the K40 the file gets there and the laser works but the default power/speed settings never change on the laser. No matter what power/speed I set the software to, the laser stays at the default. Any assistance would be much appreciated.

Thanks,

SonicDad
Tech_Marco
Posts: 4646
Joined: Mon Jun 15, 2009 3:00 pm
Contact:

Re: Power and speed settings not sending to laser

Post by Tech_Marco »

Check your connection: TTL and PWM
You may reversed the connections so that output is always High and not changeable

Marco
Post Reply

Return to “D40/K40 small chinese CO2 laser machine”

Who is online

Users browsing this forum: No registered users and 14 guests