Questions on K40 Upgrade (Power supply and parts to buy)

mikerosati
Posts: 2
Joined: Fri Apr 01, 2016 7:33 pm
Contact:

Re: Questions on K40 Upgrade (Power supply and parts to buy)

Post by mikerosati »

Thanks sgopal2 for replying with all the answers you've found - it always surprises me when people post an important question, but don't post the answer once found..

Marco - Can you answer the question above about the screws with the clips? I received them in a little bag, on their own..

I just received my k40 and the x7 upgrade kit, but as the only upgrade manual on the site for the parts is 4+ years old, it isn't current with what is included in your upgrade kit contents.. Would have been awesome to have something that gives either basics such as "we include 10 feet of 3 conductor signal wire so you can cut it up to have a total of 6 wires going to the X..." etc..
The connection/wiring diagram is great, but it can be a bit confusing for new builder to get 15 feet of two different cables, and not be sure as to which goes where :)

Thanks,
Mike
Post Reply

Return to “D40/K40 small chinese CO2 laser machine”

Who is online

Users browsing this forum: No registered users and 134 guests