What make this happend? one side is ok and other is not vertical
http://1drv.ms/1Iw2XCf
Cut problem
-
- Posts: 95
- Joined: Thu Jun 30, 2011 2:01 am
- Location: Finland
- Contact:
-
- Posts: 492
- Joined: Fri Jan 20, 2012 1:39 pm
- Location: Appelscha, the Netherlands
- Contact:
Re: Cut problem
I had exactly the same problem.
Just align the lasertube and all the mirrors properly and your problem is gone..
Kees
Just align the lasertube and all the mirrors properly and your problem is gone..
Kees
-
- Posts: 95
- Joined: Thu Jun 30, 2011 2:01 am
- Location: Finland
- Contact:
Re: Cut problem
Ok i have to try alignment againTechgraphix wrote:I had exactly the same problem.
Just align the lasertube and all the mirrors properly and your problem is gone..
Kees
-
- Posts: 95
- Joined: Thu Jun 30, 2011 2:01 am
- Location: Finland
- Contact:
-
- Posts: 492
- Joined: Fri Jan 20, 2012 1:39 pm
- Location: Appelscha, the Netherlands
- Contact:
Re: Cut problem
Ok, can you confirm that it was the alignment?
Kees
Kees
-
- Posts: 95
- Joined: Thu Jun 30, 2011 2:01 am
- Location: Finland
- Contact:
Re: Cut problem
yepTechgraphix wrote:Ok, can you confirm that it was the alignment?
Kees
Who is online
Users browsing this forum: No registered users and 85 guests