Cut problem

TeacDance · Post by **TeacDance** » Sat Dec 26, 2015 2:19 pm

What make this happend? one side is ok and other is not vertical

http://1drv.ms/1Iw2XCf

Techgraphix · Post by **Techgraphix** » Sat Dec 26, 2015 3:51 pm

I had exactly the same problem.
Just align the lasertube and all the mirrors properly and your problem is gone..

Kees

TeacDance · Post by **TeacDance** » Sun Dec 27, 2015 7:59 am

Techgraphix wrote:I had exactly the same problem.
Just align the lasertube and all the mirrors properly and your problem is gone..

Kees

Ok i have to try alignment again

TeacDance · Post by **TeacDance** » Sun Dec 27, 2015 3:16 pm

Techgraphix · Post by **Techgraphix** » Mon Dec 28, 2015 6:49 am

Ok, can you confirm that it was the alignment?

Kees

TeacDance · Post by **TeacDance** » Tue Dec 29, 2015 1:21 am

Techgraphix wrote:Ok, can you confirm that it was the alignment?

Kees

yep

Lightobject.com Support Forum