wiring the old psu for dsp upgrade

[mark seward]

hi im doing and dsp upgrade with the lo-x7 but im a bit stuck with the wiring from the psu as all the diagrams i have and have seen show different letters to the ones i have on my psu which read G/P/L/G/IN/5V offset behind the plugs and on the plugs (P+/G)(K-/K+)(G/IN/5V) and another set of 4 that reads (24/G/5V/L) What i need to know is where the 3 wires go from the laser psu to the awc708c unit

i know which were the laser +and - but i am also a little worried as the size of the wire on the volt meter is much smaller than the laser neg wire will this be ok

[geartech]

I've got the same p/s you have I think.
Here is a pin out for that p/s

http://3dprintzothar.blogspot.com/2014/ ... -with.html

there is an image on this page that has the break out for the 4-6-4 connector p/s
I'm just about done with mine just have to do a little bit more wiring clean-up and
tweaking the setup. I think I'm going to leave the laser on-off sw in the safety loop.
The only thing I have to figure out is manual trigger for beam alignment after its all back together.