Full Conversion Completed.. Unexpected Results

[WiK]

Since I was unable to figure out how to wire up the new lightobject power supply, I decided to make the full conversion. I had minor issues during the conversion, but it wasn't too bad. However my first attempt at an engraving turned out rather weird.

Please see the attachment for the fuzzy engraving.

[MACHADO3]

It´s the similar to my problem.
viewtopic.php?f=70&t=2390

I don´t know why it happens.

[Tech_Marco]

At least tell us the speed, focus lens you used. I don't think we can answer without the basic information.


Marco

[WiK]

At least tell us the speed, focus lens you used. I don't think we can answer without the basic information.


Marco

I took the focus lens out of the old unit and put it inside of the air assist unit that came with the conversion kit. That was at a speed of 200. I also tried a speed of 100 with similar results. I have also made sure the mirrors where in alignment and all belts were tight in case i knocked them loose.

[Tech_Marco]

Most likely it is an mechanic issue. Check the focus point again. Also, post the original picture if you can.
Also, if you can upload a video would be better to do the trouble shooting.

BTW, draw a square box on a pieces of paper with low output and check the cutting line. If it is a little thick, it could be the focus point issue

Marco