Hi
Test on PWM power supply is OK. Laser tube make laser beam.
But if I send data via DSP control unit no laser beam.
Laser is on DSP panel activated.
Connection diagram:
DSP AWC 608 power supply IP-40
laser1
3 - PWM IN
4 - TTL L
5 - GND G
Please help.
Communication between DSP and PWM power supply do not work
-
Sesijama
- Posts: 8
- Joined: Fri Jan 25, 2013 8:54 am
- Contact:
-
Tech_Marco
- Posts: 4647
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Re: Communication between DSP and PWM power supply do not wo
Don't forget to connect "WP" to thr ground to simulate water is activate
Marco
Marco
-
Sesijama
- Posts: 8
- Joined: Fri Jan 25, 2013 8:54 am
- Contact:
Re: Communication between DSP and PWM power supply do not wo
Tech_Marco wrote:Don't forget to connect "WP" to thr ground to simulate water is activate
Marco
Perfect! Thats it!!
Thank you
Who is online
Users browsing this forum: No registered users and 32 guests