Hi Marco
Will the DSP/Lasercad be made compatible with X6? as I am having to save out files "as x4" to convert them and its not always fully compatible.
John
CorelDraw X6
-
- Posts: 4647
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Re: CorelDraw X6
Currently the LaserCad support up to X5 (with Macro). I believe you can use X6 to save as X5 format, can't you?
It's just matter of macro issue and shouldn't have a great impact for the work itself. I'll follow up with this issue with the programmer "Li" and will give him a little pressure to make it compatible to X6
Marco
It's just matter of macro issue and shouldn't have a great impact for the work itself. I'll follow up with this issue with the programmer "Li" and will give him a little pressure to make it compatible to X6
Marco
-
- Posts: 113
- Joined: Tue Jan 29, 2013 10:46 am
- Contact:
Re: CorelDraw X6
Hi MarcoTech_Marco wrote:Currently the LaserCad support up to X5 (with Macro). I believe you can use X6 to save as X5 format, can't you?
Marco
Yes you can save as almost any previous version but you cannot guarantee the resulting files especially if there is text!
I will go back to X4 (as I have it) X6 isn't that much better......
Any chance of Turbocad being supported I have that program too !....(I cannot get on with Autocad)
John
Who is online
Users browsing this forum: No registered users and 27 guests