Hey guys! Please Help me out.
I am trying to cut this box on its origin and when I press start the laser collides with the frame at the bottom and then start cutting on the opposite side of the table
I have tried everyting, I switch negative to positive and made the 4 posible combinations with them (+ &-)in each section and nothing. the three positions are in left up. I marked x 0 y 0 as origin and the um is in perfect conditions because the 100x100 box is cutted 100x100.
Thanks in advance
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest