Very embarrassing question

Post Reply
mondo50m
Posts: 10
Joined: Sun Jan 29, 2012 1:52 pm
Contact:

Very embarrassing question

Post by mondo50m »

I have had to replace my Corel software on the computer that I use to control my laser. I have a K40 with DSP and am needing to know how to link my Corel Draw to Laser Cad so the link shows in the toolbar of Corel. I can not remember how this is done. I think it has probably been over 5 years since I last had to do this. Any help is appreciated. For some reason I believe that I had to do that from the Laser Cad software at the time of installation. I hope not, as I no longer have the install file for the software. Any help is appreciated.

Milt
Tech_Marco
Posts: 4646
Joined: Mon Jun 15, 2009 3:00 pm
Contact:

Re: Very embarrassing question

Post by Tech_Marco »

Run the LaserCad setup program and select CorelDraw from the drop down menu


Marco
Post Reply

Return to “DSP X7”

Who is online

Users browsing this forum: No registered users and 15 guests