Laser controller system-

bmolsen
Posts: 1
Joined: Fri Nov 14, 2014 1:52 pm

Laser controller system-

Postby bmolsen » Fri Nov 14, 2014 2:21 pm

I bought an older GCC Laser Pro Mercury 30 w . I have tuned this up so that it engraves and cuts good. The problem is that drivers can not be used on newer operating systems than Windows XP. I want to use this with W7 and W8 - 8.1. Must I replace controller or have any other ideas ?
If I need to replace the controller, what is recommended ?

Tech_Marco
Posts: 4351
Joined: Mon Jun 15, 2009 3:00 pm

Re: Laser controller system-

Postby Tech_Marco » Mon Dec 29, 2014 3:03 pm

Who made it? Can you post some pictures of the system and the controller card?
If it is an old card, chance is that it won't work on Win7 or Win8. But, you may try to run it at "32 bit" mode by setting up the application to "compatible mode" or "Window P mode" on Win7 and Win8


Marco

AndyKunz
Posts: 89
Joined: Fri May 02, 2014 12:38 pm
Location: Illinois
Contact:

Re: Laser controller system-

Postby AndyKunz » Tue Dec 30, 2014 12:52 pm

Another possibility is to install a virtual machine (v-box or vmware) on your machine, and then install the driver in that.

Andy

Benzamaluv
Posts: 1
Joined: Fri Oct 09, 2015 11:58 pm
Contact:

Re: Laser controller system-

Postby Benzamaluv » Sat Oct 10, 2015 12:27 am

Where can I find more information about the content on this channel for some.


Return to “Laser products”

Who is online

Users browsing this forum: No registered users and 2 guests