E5 controller x goes opposite way

Post Reply
kac1652
Posts: 2
Joined: Thu Oct 05, 2017 5:45 am
Contact:

E5 controller x goes opposite way

Post by kac1652 »

I finally finished upgrading my K40 with the new E5 and only have one issue.
For some reason the x axis nudge is backwards.
My cuts are accurate, the laser reads in the correct spots just the nudge is wrong in one axis. Any ideas why? It's not a big deal just annoying when positioning the head.

Thanks
Ken
kac1652
Posts: 2
Joined: Thu Oct 05, 2017 5:45 am
Contact:

Re: E5 controller x goes opposite way

Post by kac1652 »

Thank you Marco,
For the life of me I couldn't find that on the forums. FYI if anyone is wondering if the E5 is a worthwhile upgrade they would be crazy not to get it.
My suggestion to upgrade is to remove all the wires from the psu and steppers and run fresh wires. Much much easier to run clean wires than to chase the old mixed garbage originally installed.
Post Reply

Return to “DSP E5”

Who is online

Users browsing this forum: No registered users and 0 guests