sudden loss of power
Posted: Tue May 19, 2015 3:09 pm
I have a machine that I cut a sheet on this morning, and it cut fine. I then changed out the lense and now it wont cut.
it is in focus.
the mirrors are aligned.
the beam seems weak.
it is showing 28mA draw on the meter.
normally if I stick a piece of material in line with the beam and the first mirror it will instantly burn it. now I have to hold the laser button to even get it to darken.
any help would be appreciated.
it is in focus.
the mirrors are aligned.
the beam seems weak.
it is showing 28mA draw on the meter.
normally if I stick a piece of material in line with the beam and the first mirror it will instantly burn it. now I have to hold the laser button to even get it to darken.
any help would be appreciated.