Need Manual or Wiring Diagram for ECNC-5XBO-V8

Post Reply
GeneralSpecific
Posts: 2
Joined: Fri May 09, 2014 11:00 am
Contact:

Need Manual or Wiring Diagram for ECNC-5XBO-V8

Post by GeneralSpecific »

I purchased the "High Speed 5 Axis Break-Out Board for CNC Stepping motor. Support Mach3 and Kcam" (part number ECNC-5xBO-V8) and I need either a manual or a schematic or wiring diagram for it. I've searched everywhere and I haven't been able to find one.

Could anyone please help?

Thank you!
GeneralSpecific
Posts: 2
Joined: Fri May 09, 2014 11:00 am
Contact:

Re: Need Manual or Wiring Diagram for ECNC-5XBO-V8

Post by GeneralSpecific »

Has anyone found the manual? I've searched the internet quite a bit and haven't found another place to get this information.

Thank you!
Post Reply

Return to “CNC zone”

Who is online

Users browsing this forum: No registered users and 4 guests