Possible to wire a Compressor and Heater to JLD612?
Posted: Tue Oct 29, 2013 12:15 pm
Hi there,
Trying to wire up a fermentation chamber to keep my "beer" between 68-72F.
I bought the JLD612 controller with a 25A SSR and PT100 RTD Thermocouple.
I live in Southern California so I am not overly worried about the temperature dropping too low so the heat is just for a few degrees when needed. The SSR will run the mini fridge compressor.
I read that the relays contact volume is AC220V/3A, and for a heat source was going to use a heating lamp like this: http://www.amazon.com/Como-Ceramic-Blac ... 0v+heating
Can the light be wire off of relay 13 &14?
Here is the wiring diagram I am thinking of using:
Will this wiring diagram work? Cause any problems?
If I wanted to wire up a computer fan to provide ventilation to the box, could that be wired to the hot compressor, so every time the compressor turns on, the fan does? What kind of fuse and wiring would that need?
Thanks a million in advance!
Trying to wire up a fermentation chamber to keep my "beer" between 68-72F.
I bought the JLD612 controller with a 25A SSR and PT100 RTD Thermocouple.
I live in Southern California so I am not overly worried about the temperature dropping too low so the heat is just for a few degrees when needed. The SSR will run the mini fridge compressor.
I read that the relays contact volume is AC220V/3A, and for a heat source was going to use a heating lamp like this: http://www.amazon.com/Como-Ceramic-Blac ... 0v+heating
Can the light be wire off of relay 13 &14?
Here is the wiring diagram I am thinking of using:
Will this wiring diagram work? Cause any problems?
If I wanted to wire up a computer fan to provide ventilation to the box, could that be wired to the hot compressor, so every time the compressor turns on, the fan does? What kind of fuse and wiring would that need?
Thanks a million in advance!