jld 612 programming help
Posted: Mon Aug 19, 2013 2:13 pm
I have an oven i am trying to use for heat treating knives. I just need this oven to come up to a given temp(max 1950 f) and stay there until i turn it off..i have run through many tests and my wiring seems spot on..i am providing my current controller setting for tech review. thanks Luke
Inty. Backward 4 for k type thermocouple
Outy. 2
Atdu. 0 (this was in place of " hy" setting)
Psb. 0
Rd. 0(for heating)
C or f. 1 (for degrees f)
P. 5
I. 100
D. 20
Souf. .2
ot. 2
Filt. 0
The next settings I entered for the simulation during autotune..not sure if it's right I used the scenario in the back of manual, which wasn't all that easy to understand. Thanks for your advice.
Su. 800
Ah1 850
Al 1. 848
Ah2. 750
Al 2. 752
Inty. Backward 4 for k type thermocouple
Outy. 2
Atdu. 0 (this was in place of " hy" setting)
Psb. 0
Rd. 0(for heating)
C or f. 1 (for degrees f)
P. 5
I. 100
D. 20
Souf. .2
ot. 2
Filt. 0
The next settings I entered for the simulation during autotune..not sure if it's right I used the scenario in the back of manual, which wasn't all that easy to understand. Thanks for your advice.
Su. 800
Ah1 850
Al 1. 848
Ah2. 750
Al 2. 752