How to cut steel honeycomb?

Posts: 14
Joined: Sat Dec 31, 2016 9:42 pm

How to cut steel honeycomb?

Postby Dannym » Wed Aug 16, 2017 11:05 pm

I have some of the steel honeycomb in a frame, but I need it smaller.

I took off the frame. The individual rows aren't actually bonded. There are several tension rods running through it, each threaded the last 1/4" or so and a nut tightened onto it. This already makes it difficult to shorten in that direction, but I can figure that out. You'd just remove some rows and figure out how to re-tension those rods.

On the other sides though, it'd have to be cut. Any idea how to cut it? It's steel, not all that thick but I doubt a knife could cut it. I wonder if a sawblade would work or just shred it apart?

Posts: 1
Joined: Fri Aug 11, 2017 2:52 pm

Re: How to cut steel honeycomb?

Postby LatigoAmigo » Wed Sep 06, 2017 5:19 pm

I had the same issue and ended up using a Dremel with the reinforced cutting wheel. Went pretty well.

Return to “CO2 Laser Discussion”

Who is online

Users browsing this forum: No registered users and 4 guests