How does XLE XY Stage mount to frame?

jezter6
Posts: 3
Joined: Wed Apr 05, 2017 8:39 am

How does XLE XY Stage mount to frame?

Postby jezter6 » Tue Apr 25, 2017 6:14 am

I'm looking at the 900x600 XY stage, and it looks to be square aluminum bar. How would that mount to the Aluminum Frame Kit or a DIY frame?

Or is it now made out of the same 3030 t-slot the frame is made out of?

Winstonc
Posts: 26
Joined: Sat Feb 18, 2017 10:54 am

Re: How does XLE XY Stage mount to frame?

Postby Winstonc » Tue Apr 25, 2017 4:37 pm

There are holes in the bottom of each end of the square tube and you mount it to the extrusions using the normal bolt and square nut.

Hope that helps

David

jezter6
Posts: 3
Joined: Wed Apr 05, 2017 8:39 am

Re: How does XLE XY Stage mount to frame?

Postby jezter6 » Wed Apr 26, 2017 6:49 am

Winstonc wrote:There are holes in the bottom of each end of the square tube and you mount it to the extrusions using the normal bolt and square nut.

Hope that helps

David


Thanks WinstonC. Standard M5x8mm bolts?

Winstonc
Posts: 26
Joined: Sat Feb 18, 2017 10:54 am

Re: How does XLE XY Stage mount to frame?

Postby Winstonc » Fri Apr 28, 2017 1:31 pm

I just used the same bolts that came with my extrusion kit which where m6 x 12mm.

David


Return to “CO2 Laser Discussion”

Who is online

Users browsing this forum: No registered users and 2 guests