Magnetic switch on door

Post Reply
htrowrod
Posts: 25
Joined: Wed Jan 04, 2017 1:24 am
Contact:

Magnetic switch on door

Post by htrowrod »

I am trying to hook up the magnetic safety on the laser door. I hooked one wire from magnet to 1 in and the other wire form magnet to gnd. The laser worked when the door was open and wouldn't work when door was closed.

Thanks,
Bruce
Techgraphix
Posts: 492
Joined: Fri Jan 20, 2012 1:39 pm
Location: Appelscha, the Netherlands
Contact:

Re: Magnetic switch on door

Post by Techgraphix »

What kind of controller do you have?
I thought you can invert the function in the X7.

Kees
htrowrod
Posts: 25
Joined: Wed Jan 04, 2017 1:24 am
Contact:

Re: Magnetic switch on door

Post by htrowrod »

I am using the X7 DSP controller

Bruce
Techgraphix
Posts: 492
Joined: Fri Jan 20, 2012 1:39 pm
Location: Appelscha, the Netherlands
Contact:

Re: Magnetic switch on door

Post by Techgraphix »

If you haven't found it yet:
When you press STOP and SHIFT simultanious, you enter the manufacturer settings.
Ther you see Option 3: IO Parameters. Select that.... there you see "Open protection", set that to "Open" and set "Input Valid Level" to "High Level" if it was "Low Level" or vice versa..

Kees
Post Reply

Return to “CO2 Laser Discussion”

Who is online

Users browsing this forum: No registered users and 13 guests