exhaust control by CO2 laser

Post Reply
awrdbob
Posts: 7
Joined: Wed Aug 31, 2016 2:58 pm
Contact:

exhaust control by CO2 laser

Post by awrdbob »

New to the forum so if I am in the wrong sub-forum, sorry, then move my question.

So I have a Gravograph LS100 and a non-Gravograph exhaust fan. Due to the preparatory nature of the Gravograph products, they want be to buy their exhaust and I don't. They will not tell me how to activate my exhaust fan.

I have found that two of the 5 pins on the exhaust connection (the connection used by their equipment) "go positive" with a 5 volt signal when the laser is active. I suspect this is a 5 volt, very small milliamp power source. Does anyone know how much power is the minimum requirement to activate a ESSR-25DAC solid state relay? Could I activate my exhaust with this relay?
Post Reply

Return to “CO2 Laser Discussion”

Who is online

Users browsing this forum: No registered users and 29 guests