XLE 600 X 400 Stepper Motor wiring

Post Reply
Harldave
Posts: 15
Joined: Sun Feb 07, 2016 5:59 pm
Contact:

XLE 600 X 400 Stepper Motor wiring

Post by Harldave »

Can anyone tell me which of the 6 wires on the motors goes to the stepper driver?? Which are pairs? Do ALL 6 wires get used?
Attachments
00.jpg
jhuangupp
Posts: 9
Joined: Thu Mar 31, 2016 10:04 am
Contact:

Re: XLE 600 X 400 Stepper Motor wiring

Post by jhuangupp »

It seem to me that you have a 2 phase driver? Can you provide the stepper driver model number and the motor model number?
Harldave
Posts: 15
Joined: Sun Feb 07, 2016 5:59 pm
Contact:

Re: XLE 600 X 400 Stepper Motor wiring

Post by Harldave »

I will get that info. But I suspect I don't have the right drivers for the motors that I have. They are the micro drivers..
Any Ideas Marcos? Since I bout all of this from Light Objects??
Techgraphix
Posts: 492
Joined: Fri Jan 20, 2012 1:39 pm
Location: Appelscha, the Netherlands
Contact:

Re: XLE 600 X 400 Stepper Motor wiring

Post by Techgraphix »

Seen from the picture, your wires are colored: Red, White, Blue, Green, Yellow and Black
As this motor has 6 wires, i suspect that this an unipolar motor, but you could connect that to a Bipolar driver.
This unipolar motor has 2 coils with a connection to the middle. You should ommit this middel connection.
The colors that are important are:
Red = A Blue = /A Green = B Black = /B
So the wires White and Yellow can he isolated.
BUT: first measure if the coils are between Red and Blue / Green and Black with an Ohm-meter... Just to be sure that this motors have the wires conected as they should have
See: http://www.linengineering.com/resources ... nnections/
Kees
Post Reply

Return to “CO2 Laser Discussion”

Who is online

Users browsing this forum: No registered users and 24 guests