AWC708C Lite Controller wiring???

Post Reply
WVJoe
Posts: 30
Joined: Tue Mar 29, 2016 5:00 pm
Contact:

AWC708C Lite Controller wiring???

Post by WVJoe »

I notice there are 2 cables with 12 pin plugs that came with my kit. Am I to cut the 1 end off each cable and wire the cut end to ???? That's where I am right now, I need an instructable please. Preferably for the AWC708C Lite controller I purchased, covering the controller to laser tube ps, controller to drivers, etc., etc.

Thanks in advance!
Tech_Marco
Posts: 4646
Joined: Mon Jun 15, 2009 3:00 pm
Contact:

Re: AWC708C Lite Controller wiring???

Post by Tech_Marco »

No cut here!
Just connect the cables to CN1 and CN2 from the control unit to main board.

Marco
WVJoe
Posts: 30
Joined: Tue Mar 29, 2016 5:00 pm
Contact:

Re: AWC708C Lite Controller wiring???

Post by WVJoe »

Tech_Marco wrote:No cut here!
Just connect the cables to CN1 and CN2 from the control unit to main board.

Marco
I see it! CN1 is marked so I am assuming that the one next to it is for CN2. Thanks very much Marco.
WVJoe
Posts: 30
Joined: Tue Mar 29, 2016 5:00 pm
Contact:

Re: AWC708C Lite Controller wiring???

Post by WVJoe »

Now that I see where the 2 cables plug in from the controller to the mainboard is there a wiring manual for the rest? You know, what wires go where, is the e-kill N/O or N/C, limits N/O or N/C, etc,?
Post Reply

Return to “CO2 Laser Discussion”

Who is online

Users browsing this forum: No registered users and 22 guests