"Overshoot" spots during engrave

DonL
Posts: 175
Joined: Sun Nov 08, 2015 7:32 am
Location: Canada
Contact:

Re: "Overshoot" spots during engrave

Postby DonL » Thu Apr 14, 2016 6:29 pm

Yes, 4 Nylon wheels ridding on an aluminium bar tends to be a recipe for vibration and any dirt on the bar is a bump in the road so more vibration... I notice more expensive units use a 2-bar and bushing system much like the Y axis has onlu it is a single bar or they use much higher quality rollers. I purchased a spare set of rollers so I may try them. And and then look around for something I can retro-fit that will give a smooth fast X Asis.


Return to “CO2 Laser Discussion”

Who is online

Users browsing this forum: No registered users and 5 guests