stray lines from Corel to LaserCAD

Post Reply
DonL
Posts: 175
Joined: Sun Nov 08, 2015 7:32 am
Location: Canada
Contact:

stray lines from Corel to LaserCAD

Post by DonL »

It seems lately that when I export a drawing from Corel, it has all these extra lines... I must have changed something... Anyone else seen this?
it is a pain to spend more time cleaning up than to draw.... Corel X7 text or curves, doesn't matter
lines.JPG
lines.JPG (17.38 KiB) Viewed 1195 times
UPDATE: I had a old config file where I exported the software settings so I imported those settings and the problem is gone... so it was something in the software config... I would like to know though...
Post Reply

Return to “CO2 Laser Discussion”

Who is online

Users browsing this forum: No registered users and 30 guests