I tgurned on SLOPE engrave and specified a 2mm slope, I then sent some 15mm high text to the DSP with a chunk of wood in the laser.
What I expected was a nice gradual slope to the character like the fist one but got more like 2 and 3 in the drawing below... Anyone know why slope only works on verticle lines with LaserCAD?
I would like to engrave sloped letters on various materials but this is totally useless... Another BUG in LaserCAD ?
Slope Engrave only slopes virticle lines not horizontal?
-
- Posts: 175
- Joined: Sun Nov 08, 2015 7:32 am
- Location: Canada
- Contact:
Who is online
Users browsing this forum: No registered users and 11 guests