water flow/pressure sensor connection LSR-H2OPRSN

Post Reply
neuman5022
Posts: 27
Joined: Sat Aug 22, 2015 7:15 pm
Contact:

water flow/pressure sensor connection LSR-H2OPRSN

Post by neuman5022 »

Hi Guys,

Can'r figure out this little gizmo...


Unit came with a T connector, and a 7mm small tube....

What is he small tube for ?

Does the 90 degrees way of the connector go to the inlet ?

There is a small screw with Phillips head - is this for adjusting the triggering flow ?

On the back there is a knob you can turn an arm that pushes the spring - what does this do ?

A diagram or few words will help a lot....

Many thanks

Isaac
jhuangupp
Posts: 9
Joined: Thu Mar 31, 2016 10:04 am
Contact:

Re: water flow/pressure sensor connection LSR-H2OPRSN

Post by jhuangupp »

What is the small tube for ?
ANS: The tube is to connect the T connector with the water sensor.

Does the 90 degrees way of the connector go to the inlet ?
ANS: YES, T connector go to inlet of the water sensor. It is a little hard to connect both the T connector and the inlet together. :D

There is a small screw with Phillips head - is this for adjusting the triggering flow ?
ANS: The small screw is to hold the plastic head in place.

On the back there is a knob you can turn an arm that pushes the spring - what does this do ?
ANS: The knob is to adjust the triggering pressure. If you have a low volume output water pump, make sure the plastic head with a screw is in a low position.
neuman5022
Posts: 27
Joined: Sat Aug 22, 2015 7:15 pm
Contact:

Re: water flow/pressure sensor connection LSR-H2OPRSN

Post by neuman5022 »

Thanks for the answer.

IMHO - this information should be sent with the product itself, ths way you can avoid these kind of questions...

Cheers

Isaac.
warboss72
Posts: 2
Joined: Sat Feb 23, 2019 5:07 am
Contact:

Re: water flow/pressure sensor connection LSR-H2OPRSN

Post by warboss72 »

I agree with above. I have 60 watt laser and have no way of knowing how to wire water sensor up for it to work properly. Any information would be great
warboss72
Posts: 2
Joined: Sat Feb 23, 2019 5:07 am
Contact:

Re: water flow/pressure sensor connection LSR-H2OPRSN

Post by warboss72 »

I have a cw3000 chiller and it came with a sensor plug. How would I go about wiring it up to that?
Techgraphix
Posts: 492
Joined: Fri Jan 20, 2012 1:39 pm
Location: Appelscha, the Netherlands
Contact:

Re: water flow/pressure sensor connection LSR-H2OPRSN

Post by Techgraphix »

On page 5 of the manual you will find the connection:
https://www.hi-end.ro/upload/files/CW-3000-hiendro.pdf
Kees
Post Reply

Return to “Electronics”

Who is online

Users browsing this forum: No registered users and 11 guests