22'' LCD Touch Kit

Ortenberg2013
Posts: 2
Joined: Thu Sep 05, 2013 8:47 am

22'' LCD Touch Kit

Postby Ortenberg2013 » Thu Sep 05, 2013 8:56 am

Hi!
I bought a 22'' Touch-Overlay for my LCD-Monitor. Now when I wanna set it up, the mouse goes to the left when i swipe my finger to the left and it goes to the right when I swipe it to the right. But when I go up the mouse goes down and vice versa. In addition the mouse is always about 2 - 3 inches above the point i touch the panel. Because of that I am unable to configurate.
Please help!

Thanks
Niklas

Tech_Marco
Posts: 4401
Joined: Mon Jun 15, 2009 3:00 pm

Re: 22'' LCD Touch Kit

Postby Tech_Marco » Sat Sep 07, 2013 11:47 am

What about use the other side of the panel? Or, revese the connector and try it

Marco

Stephen6309
Posts: 15
Joined: Thu Jun 21, 2012 7:09 am
Location: Florida Space Coast

Re: 22'' LCD Touch Kit

Postby Stephen6309 » Sat Sep 07, 2013 3:24 pm

You need to run the calibration program. It should have been installed with the driver.

Ortenberg2013
Posts: 2
Joined: Thu Sep 05, 2013 8:47 am

Re: 22'' LCD Touch Kit

Postby Ortenberg2013 » Sun Sep 08, 2013 10:30 am

Thanks for your replies.
Using the other side of the panel does not work because there's just one side of the panel that is touch-sensitive.
I also tried to get it work with the other side of the connector. Same thing...


Return to “Electronics”

Who is online

Users browsing this forum: No registered users and 3 guests