Page 1 of 1
DC-DC step up power module
Posted: Fri Apr 26, 2013 8:11 am
by dreld
For the 6v to 12v DC-DC step up power module:
1) Where do I connect a heat sink?
2) How hot will this get if one is not used?
3) Will it get hot only under load or any time it is powered?
Thanks
Re: DC-DC step up power module
Posted: Tue Apr 30, 2013 9:42 am
by Tech_Marco
You may attach a small heating to the IC and/or the coil. It got hot if you drive over 1A current. It will not get hot if no load
Marco
Re: DC-DC step up power module
Posted: Fri Apr 11, 2014 10:32 am
by Entropykls
For the DC to DC power module step up Input 3.5V - 26.5V output used as voltage regulator for a solar panel, how do you set it to 12V max? Couldn't find manual. Sorry if this is in the wrong place on board.
Re: DC-DC step up power module
Posted: Fri Apr 11, 2014 11:20 am
by Tech_Marco
Can you post the link or the image to let me see which one did you have?
Usually there is a VR (variable resistor) pot allow one to change output
Marco
Re: DC-DC step up power module
Posted: Fri Apr 11, 2014 6:41 pm
by Entropykls
http://www.lightobject.com/DC-to-DC-pow ... -P498.aspx
Since this is the one recommended for use with solar panels, does it also step down the voltage if it comes in higher than 12V?
Re: DC-DC step up power module
Posted: Fri Apr 18, 2014 5:49 pm
by Entropykls
Hello? Anyone there?