DC-DC step up power module

Post Reply
dreld
Posts: 1
Joined: Fri Apr 26, 2013 8:01 am
Contact:

DC-DC step up power module

Post by dreld »

For the 6v to 12v DC-DC step up power module:
1) Where do I connect a heat sink?
2) How hot will this get if one is not used?
3) Will it get hot only under load or any time it is powered?

Thanks
Tech_Marco
Posts: 4646
Joined: Mon Jun 15, 2009 3:00 pm
Contact:

Re: DC-DC step up power module

Post by Tech_Marco »

You may attach a small heating to the IC and/or the coil. It got hot if you drive over 1A current. It will not get hot if no load

Marco
Entropykls
Posts: 3
Joined: Fri Apr 11, 2014 10:08 am
Contact:

Re: DC-DC step up power module

Post by Entropykls »

For the DC to DC power module step up Input 3.5V - 26.5V output used as voltage regulator for a solar panel, how do you set it to 12V max? Couldn't find manual. Sorry if this is in the wrong place on board.
Tech_Marco
Posts: 4646
Joined: Mon Jun 15, 2009 3:00 pm
Contact:

Re: DC-DC step up power module

Post by Tech_Marco »

Can you post the link or the image to let me see which one did you have?
Usually there is a VR (variable resistor) pot allow one to change output

Marco
Entropykls
Posts: 3
Joined: Fri Apr 11, 2014 10:08 am
Contact:

Re: DC-DC step up power module

Post by Entropykls »

http://www.lightobject.com/DC-to-DC-pow ... -P498.aspx

Since this is the one recommended for use with solar panels, does it also step down the voltage if it comes in higher than 12V?
Entropykls
Posts: 3
Joined: Fri Apr 11, 2014 10:08 am
Contact:

Re: DC-DC step up power module

Post by Entropykls »

Hello? Anyone there?
Post Reply

Return to “Electronics”

Who is online

Users browsing this forum: No registered users and 14 guests