DC-DC step up power module

dreld
Posts: 1
Joined: Fri Apr 26, 2013 8:01 am

DC-DC step up power module

Postby dreld » Fri Apr 26, 2013 8:11 am

For the 6v to 12v DC-DC step up power module:
1) Where do I connect a heat sink?
2) How hot will this get if one is not used?
3) Will it get hot only under load or any time it is powered?

Thanks

Tech_Marco
Posts: 4404
Joined: Mon Jun 15, 2009 3:00 pm

Re: DC-DC step up power module

Postby Tech_Marco » Tue Apr 30, 2013 9:42 am

You may attach a small heating to the IC and/or the coil. It got hot if you drive over 1A current. It will not get hot if no load

Marco

Entropykls
Posts: 3
Joined: Fri Apr 11, 2014 10:08 am

Re: DC-DC step up power module

Postby Entropykls » Fri Apr 11, 2014 10:32 am

For the DC to DC power module step up Input 3.5V - 26.5V output used as voltage regulator for a solar panel, how do you set it to 12V max? Couldn't find manual. Sorry if this is in the wrong place on board.

Tech_Marco
Posts: 4404
Joined: Mon Jun 15, 2009 3:00 pm

Re: DC-DC step up power module

Postby Tech_Marco » Fri Apr 11, 2014 11:20 am

Can you post the link or the image to let me see which one did you have?
Usually there is a VR (variable resistor) pot allow one to change output

Marco

Entropykls
Posts: 3
Joined: Fri Apr 11, 2014 10:08 am

Re: DC-DC step up power module

Postby Entropykls » Fri Apr 11, 2014 6:41 pm

http://www.lightobject.com/DC-to-DC-pow ... -P498.aspx

Since this is the one recommended for use with solar panels, does it also step down the voltage if it comes in higher than 12V?

Entropykls
Posts: 3
Joined: Fri Apr 11, 2014 10:08 am

Re: DC-DC step up power module

Postby Entropykls » Fri Apr 18, 2014 5:49 pm

Hello? Anyone there?


Return to “Electronics”

Who is online

Users browsing this forum: No registered users and 2 guests